Ellipse

To place a markup ellipse, perform the following steps:

1.     Use Object Snaps if required.

2.     Set the line colour, line type, line style and fill colour of the ellipse via the Format panel prior to place the ellipse.

3.     Click the Ellipse button on the Markup panel of the Markup ribbon.

4.     On the drawing, pick a corner point of the ellipse and hold the mouse button.

5.     Drag the cursor to a diagonally opposite corner.

6.     When the ellipse is at the correct size, release the mouse button.

Note: After picking the first point, holding the Shift key whilst dragging to the opposite corner will draw a circle instead of an ellipse.

7.     The command will continue until the Esc key is pressed.