Polyline

To draw a series of linked lines as single markup object, perform the following steps:

1.     Use Object Snaps if required.

2.     Set the line colour, line type and line style of the polyline via the Format panel prior to drawing the polyline.

3.     Click Polyline button on the Markup panel of the Markup ribbon.

4.     On the drawing, pick the start point.

5.     Move the cursor and pick the next point of line.

6.     Repeat picking line points.

7.     Press the Return key or right-click to finish drawing the line.

8.     After picking a point press and hold the Shift key to draw the next line segment orthogonally up or down or across the screen. The command will continue until the Esc key is pressed.